OS is Vista 32bit

Modem work , just wont connect with V22, 1200b/s 8N1 from old fashin terminal program (start to handshake and drop connection)

• other pcmcia modem works from tecra laptop without extra init string,
• others laptops (no toshiba) connect without extra settings (conexant modem)

at#ud
DIAG <2A4D3263 0=10>
DIAG <2A4D3263 1=8 2=0 3=0>
DIAG <2A4D3263 10=00 11=0A 12=00>
DIAG <2A4D3263 17=03E8>
DIAG <2A4D3263 20=FF 22=0000 24=000>
DIAG <2A4D3263 21=FF 23=0000 25=000>
DIAG <2A4D3263 26=0000 34=2580>
DIAG <2A4D3263 27=0000 35=2580>
DIAG <2A4D3263 31=00 32=00 33=00>
DIAG <2A4D3263 40=0
DIAG <2A4D3263 50=2 51=2>
DIAG <2A4D3263 52=00000000 54=0>
DIAG <2A4D3263 53=00000000 55=0>
DIAG <2A4D3263 61=00>
DIAG <2A4D3263 60=5E>

in translaton

---

Diag Command Specification rev.: 1.0
Call Setup Result code : Data Calling signal detected
Multi-media mode : Data Only
DTE-DCE interface mode : Async data
TX/RX signal power level, -dBm : 10/0
Estimated noise level, -dBm : 0
Round Trip/Far echo delay, ms : 1000/NA
TX/RX Symbol Rate : 0/0
TX/RX Carrier frequency, Hz : 0/0
TX data rate (Last/Init) : 9600/0
RX data rate (Last/Init) : 9600/0
Carrier Rate Re-neg count : 0
Retrains Requested/Granted : 0/0
Protocol/Compression : Disable/none / NA
TX/RX flow control : V.24 ckt 106/133 / V.24 ckt 106/133
TX/RX chars sent : 0/0
TX/RX chars lost (data overrun): 0/0
Termination Cause : Negotiation Failed
Call Waiting event count : 0

ati11
Description Status

---

---

Last Connection Unknown
Initial Transmit Carrier Rate 0
Initial Receive Carrier Rate 0
Final Transmit Carrier Rate 9600
Final Receive Carrier Rate 9600
Protocol Negotiation Result NONE
Data Compression Result NONE
Estimated Noise Level 0
Receive Signal Power Level (-dBm) 00
Transmit Signal Power Level (-dBm) 10
Round Trip Delay (msec) 1000
Near Echo Level (-dBm) 00
Far Echo Level (-dBm) 00
Transmit Frame Count 0
Transmit Frame Error Count 0
Receive Frame Count 0
Receive Frame Error Count 0
Retrain by Local Modem 0
Retrain by Remote Modem 0
Rate Renegotiation by Local Modem 0
Rate Renegotiation by Remote Modem 0
Call Termination Cause 4 -- protocol failure if required by \N4, for example.
Robbed-Bit Signaling 0
Digital Loss (dB) 00
Remote Server ID NA

I supose that I need init string for V22 (I tried at+ms=v22 without success)
Thanks

Message was edited by: pedjaj